Changes for ASC3

V20.11	2020-11-27
    Interface-Problems solved
    Mistake in program 5.2 solved

V19.81    2019-08-15
    improvement auto calibration 
	bugfix: Daytime was sometimes wrong displayed on PC interface
    add Program 52  	
  
V18.91 (S6218) 2018-12-17
    Bugfix Prg.4 Countdown -20 Traffic light = red

V18.41 (S5889)		2018-11-09
    Bug fix Baudrate will be stored

V17.61 	2017-06-27
    Two new parameters: "bIb" (ID-number) and "brt" (brightness).
    bIb = on - BIB is always ON at start up
    bIb = off - will be on or off depending on settings before switching off ASC3
    brt = on - Brightness is maximum 9 on start up
    brt = off - Brightness depends on previous settings before switching off ASC3

V17.51 	2017-05-29
    Bugfix in GPS sync.
    ASC3 has triggered on the falling edge instead of the rising, caused a 100ms delay of the daytime

V16.91		2016-12-21
    some stability fixes
    The command for the slave-mode was slightly changed.
    Serial command to adjust potential free contact

V15.91		2015-09
    Addressing in Slave Mode now possible

V15.81(S1581)    2015-08-31
    bug fix wrong countdown time program 8.(+/-3sec.)
    GPS leap sec. changed to 17sec. factory reset does not change GPS settings.
    Address number changed from A,B;C... to 1,2,3...


V15.61 (S1561)   2015-06-26
    bug fix factory default setting
    Change display SW Version now ALGE standard (e.g. S1561)
    new PC Commands see ASC3-BE-Serial-Protocol 
   

s4686    2015-03-05
    Possibility of addressing added
    When entering slave mode the current address is shown on the last digit
    Error: If setting ASC3 on factory default display was not readable

S4504    2014-10-03
    Some (invisible) improvements

s4455    2014-09-06
    sw with solved printer bug (now is min 100ms between 2 starts)